Correct use of drill bits and precautions

Drill bit is a kind of commonly used hardware tool products. Although the size of the drill bit is relatively small, it is inseparable from the modern industrial construction industry. The drill bit also needs to pay attention to some matters during the use process, so as to ensure that it can be used normally. , It can also ensure its safety in use. What are the precautions for the use of the drill bit。
1. The storage of the drill bit should be moisture-proof and ventilated.In the process of transportation, it is strictly forbidden to bump the cones and threads.?
2. It is strictly forbidden to use curved drill pipes to avoid uneven force on the three palms of the drill bit and accelerate the damage of the drill bit.?
3. During normal perforation operations, the main air path of the air compressor should not have serious air leakage to ensure sufficient air volume and air pressure to extend the service life of the wholesale rock drill bits.?
4. When the drill bit is in the hole and the air compressor suddenly stops working, the slag can easily enter the drill bit. Therefore, it is strictly forbidden to rotate for a long time, which will cause bearing wear, repeated broken slag (or stuck), and accelerated drill bit wear..?
5. When the drilling tool is in the hole, it is strictly prohibited to reverse to prevent the drill bit from falling into the well.?
6. When a new drill bit is used for drilling, it should be used with low axial pressure and low speed for 20-30 minutes, and then gradually increase to normal axial pressure..?
7. When making a new hole with a new drill bit, pay attention to clear the debris around the hole (rocks, scrap metal, etc.), while rotating, ventilate slowly, close to the surface, and prevent sudden drilling and impact damage to the drill bit.?
8. The drill bit should be stored reasonably on the rig to prevent dust and other debris from entering the drill bit.?
9. Please check the appearance of each part of the drill bit before going down the well, verify that the end face of the drill bit thread is consistent with the factory number on the drill bit packing box and certificate; whether there is a cutting-edge trademark mark on the surface of the drill bit tooth palm to prevent counterfeiting.?
10. When drilling rigs, they must follow the principle of matching the three elements of the drilling (wind pressure, axial pressure, and speed) with the parameters recommended by the drill bit sample..?
11. When working in different rock formations, choose different types of drill bits, axial pressure and speed according to the hardness of the lithology; working in soft rock formations, replacing the drill bit in the middle, strictly check the alloy on the back of the palm of the old drill bit and the cone Whether the teeth have fallen off to the bottom of the hole, if there are residues of the old bit in the hole, it is strictly forbidden to use a new drill bit in the original hole; when the rock has cracks or the rock cracks caused by blasting and the work in the goaf, reduce the axial pressure And speed to prevent teeth from breaking.

Laisser un commentaire

Cheobommentres |
Quicranatta |
Akoutlethe | | Annuaire | Signaler un abus | Pumpfoam92
| Rzeszowadwokat090
| Burke27mercer